Home > Download > File download >K series connector plug assembly instruc…

K series connector plug assembly instructions


Plug assembly instructions:

K series connector plug

1. The cable is sequentially passed through the sheath 1, the tail nut 2, the cable clamp 3, the v-shaped pad 4, the cable sealing ring 5, the shielded wire ring 6, and soldered to the corresponding pins of the insulator assembly 7 in order.

2. Attach the insulator snap ring 7 to the insulator assembly 8. Note that the protrusion of the insulator snap ring 7 corresponds to the notch of the insulator assembly 8, and the shield wire loop 6 is sequentially replaced, the cable seal ring 5, the v-shaped pad 4, and the cable clamp 3 Push it into the proper position and ensure that the complete outer skin of the cable is inserted into the shielded wire loop 6.

3. Install the mounted insulating assembly 8 into the header assembly 9, noting that the notch in the insulator snap ring 7 corresponds to the protrusion in the plug assembly 9.

4. Screw the tail nut 2 onto the plug assembly 9.

5. Attach the sheath 1 to the tail nut 2.

Scan the qr codeClose
the qr code